12/31/2023 0 Comments Diy kite boat![]() Tie ribbons of left-over plastic at regular intervals to it. Attach a length of twine (about 120cm/4′) to the bottom end of the spine as a tail. This will require some experimenting to find the best spot, but start at a point near the top of the kite.ĩ. By choosing where you attach the string, you control the angle at which the kite flies. The bridle should be long enough so when you pick up the kite by it, it’s at least 20cm (8″) from the kite’s surface.Ĩ. Do the same with the other end of the twine at the other hole. To make the bridle, feed a length of twine through the hole at the top and tie it to the spine. It’s a good idea to reinforce these holes with tape.ħ. Punch two small holes along the spine for the bridle. ![]() ![]() Use tape to secure to the dowels and the twine, with extra reinforcement at the ends.Ħ. Lay the frame flat, with the crosspiece facing up.ĥ. This will help keep the dowels properly at right angles to each other. Run twine from one end of the crosspiece, to the top end of the spine, to the other end of the spine. It is important that they remain at right angles to each other, and the mid point of the crosspiece is directly on the spine.Ĥ. Fasten the two dowels together using twine and tape. Place the middle point of the crosspiece at right angles on the spine, about 30cm (12″) from one end.ģ. Measure and locate the middle point on the crosspiece, mark with a pencil. Then get your ‘How to make a kite’ building materials together.Ģ. Get creative by decorating your kite design using paints, markers, or stickers.ġ. This Do-it-Yourself project takes 10-steps and one hour to complete.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |